UAZ car
Removing the steering gear for replacement or repair
We install the car on a viewing ditch or lift
We replace the supports if they are worn out
We prepare the car and install it on a viewing ditch or lift
In the article, we will look at how to replace candles and adjust the ignition timing
We discussed the removal and disassembly of the UMP engine in previous articles
In this article, we will consider the stages of assembling the UMP engine
We remove the ignition distributor sensor for repair, as well as for replacement
The system consists of a recirculation valve with a diaphragm, a thermal vacuum switch and two hoses
Mechanical three-shaft gearboxes of three types are installed on UAZ vehicles:
- - four-speed, with synchronizers only in III and IV gears;
The exhaust system consists of a front pipe, silencer and resonator
The electrical equipment of the car is made according to a single-wire circuit: the negative terminals of sources and consumers of electricity are connected to the body and other units of the car, which act as a second wire
The car can be equipped with a starter 42.3708 or 4211.3708-01 or 62.3708
Starters have almost the same design
We remove the belt due to wear or when repairing engine systems
We perform work on a lift or on a viewing ditch
