UAZ car

These two-axle, all-terrain vehicles, with front and rear drive axles (4x4 wheel arrangement), are designed to transport people and cargo on all types of roads and off-road. Vehicles equipped with a towing hitch and shock-absorbing device can tow a single-axle trailer with a gross weight of up to 850 kg. Vehicles with a rigid towing device may only be used as a towing vehicle for short periods.

Remove the transfer case for repair or replacement

We prepare the car and install it on a viewing ditch or lift

  1. How to replace the crankshaft seals of the UAZ-3151, -31512, -31514, -31519 engine
  2. Removal of fuel system elements UAZ-3151, -31512, -31514, -31519
  3. Removal of the connecting rod-piston group of the UAZ-3151, -31512, -31514, -31519 engine

Articles

We remove the cylinder head for repair, to replace the gasket under the head and for a complete engine overhaul.

We remove the lining of the car floor tunnel to remove the instrument panel, and if necessary We prepare the car and disconnect the negative battery terminal

In the article, we will consider the removal of the axle shaft, the replacement and adjustment of the hub bearings, the removal of the rear axle

We check the coolant level daily before the trip. The fluid level should be checked on a cold engine.

If the intake manifold is leaking, the engine starts to run unevenly (troit) If tightening the intake manifold mount fails to eliminate the leakage, then the gasket must be replaced

Place the vehicle on a two-post lift Raise the vehicle until the wheels are a few centimeters off the floor