The engine of a car is the engine that drives a car.
This section describes the design, maintenance, and repair of engines.
Some engines and their features are described directly in the sections that describe this vehicle.
We covered the removal and installation of the cylinder head in the previous article.
1. Using a valve spring compressor, extract the split collets from the valve spring retainer. Then remove the valve spring retainer, the valve spring, the valve spring seat and the valve itself.
1. Check the side clearance between the lower connecting rod end and the corresponding crankshaft cheek.
We install the cylinder block on the stand for disassembly and assembly of units
The main dimensions of the connecting rod and piston group are shown in Figure 1.
The piston is cast aluminum. The mass of the pistons is strictly maintained in the manufacture.
Disassembly of the cylinder block was discussed in the article - "Disassembly of the cylinder block"
After disassembling the cylinder block, it is necessary to determine the possibility of further use of the cylinder block, crankshaft and piston group.
Select your language
