UAZ car
Let's consider the removal of the connecting rod and piston group without removing the engine from the car
We discussed the removal and disassembly of the UMP engine in previous articles
In this article, we will consider the stages of assembling the UMP engine
The engine oil must be changed in accordance with the maintenance schedule for each specific vehicle.
Usually, the mileage of a car before the next oil change is 10-15 thousand km
In the article, we will consider the disassembly and removal of the car door
Removing the door trim
We prepare the car for the task, install it on a horizontal platform and remove the wheel from the side of the work being done
Adjustment of the regulator is necessary after replacing the rear springs or the rear axle, as well as during the operation of the car
We remove the steering knuckle and axle shaft for repair, as well as for replacement
We remove the ignition distributor sensor for repair, as well as for replacement
In the article, we will look at how to replace candles and adjust the ignition timing
The electrical equipment of the car is made according to a single-wire circuit: the negative terminals of sources and consumers of electricity are connected to the body and other units of the car, which act as a second wire
We adjust the carburetor dampers after repair work related to the removal of damper actuators