Disassembling the engine for overhaul.
Usually, an overhaul of the engine is required with a large motor resource, with a decrease in oil pressure and a decrease in compression in the engine cylinders
In figure 1, a diagram of the Foton Aumark ISF3.8 CM2220 electronic engine control system without SCR from 2010
The phase sensor signal is used by the controller to organize sequential fuel injection in accordance with the order of operation of the engine cylinders
Combined diesel lubrication system
Oil pump - gear type, single section
- Removal and installation of the intake manifold of the K4M engine
- Installation of pistons and rings Diesel 740 KAMAZ
- Replacement of DMRV VAZ-2123 with electronically controlled throttle valve for EURO-5
- Adjustment of clearances in the valve drive ZMZ-402
- How to remove the receiver and intake manifold of the VAZ-2112 engine
- Diesel power system D-245.7E3 / D-245.9E3
- Replacing the timing belt on the VAZ-2112 engine
- Disassembly of the cylinder block of the K4M engine
- Removing elements of the Cummins ISF3.8 air intake system
- Feature of the crank mechanism of the KAMAZ-740.50-360, KAMAZ-740.51-320 engines
- Dismantling and troubleshooting of the crankshaft ZMZ-402
- Features of the ECM with an electronic gas pedal VAZ-2123
- Diesel engine cooling system D-245.7E3 / D-245.9E3
- Disassembly and assembly of the cylinder head ZMZ-402
- How to replace the hydraulic valve lifters of the VAZ-2112 engine